If you would like to reply to this thread, please log in. If you do not have an Ask the Experts forum user account, create one here.
If you would like to reply to this thread, please log in. If you do not have an Ask the Experts forum user account, create one here.
I have a few rusted sections or drip edge need replacement.
Any tricks to taking out old drip
fastening pattern 12 in.
getting screws in same hole, is that a concern
after removal can i put down a 4 inch adhesive roofing product over the section and place drip edge over that with or without butyl?
thank you
7/20/2022
Or copy this URL: https://www.metalroofing.com/spirit/comment/25979/find/I think this will be very difficult to do without removing the roof panels. Is that, though, what you'd like to do?
Isaiah Industries, Inc.
7/20/2022
Or copy this URL: https://www.metalroofing.com/spirit/comment/25980/find/i am thinking of going back two or three feet and removing the screws. At that point i may be able to slip a 1x2 firing above the drip edge and depending on how much lift i can get either 3/4 or 1.5 inches to give me some room to work. there are three 10 foot sections and it is a hip. If taking out the panels i would have to take out the hip and ridge cap along with the panels. With doing it that way would i have to reseal the entire section?
7/20/2022
Or copy this URL: https://www.metalroofing.com/spirit/comment/25981/find/