Flashing for metal roof: "We have a corrugated metal roof & I need info ..." - Guest User (1/8/2008) | Flashing | Archive

This topic has been closed by the administrator. Comments are no longer accepted.

We have a corrugated metal roof & I need info on installation of a double wall flue with rubber boot flashing, on a 4/12 pitch. I have a dektite boot but am considering a selkirk boot flashing kit. Question is, do I need the kit or just a boot?	Guest User 1/8/2008	Share Or copy this URL: https://www.metalroofing.com/spirit/comment/10763/find/
Silicone rubber roof jacks have a temperature rating of 400 degrees. Attached is a picture of one installed on a metal roof. It is installed on a "pipe curb" because its diameter would have blocked the water flow down the panel. Notice the stainless steel band around the top to prevent water infiltration due to snow accumulation.	Ken Buchinger NCI Building Systems, Inc. 1/9/2008	Share Or copy this URL: https://www.metalroofing.com/spirit/comment/10764/find/
Thanks for the picture. Contractor installed a rubber boot with flexible metal flashing and sealed with silicone. They said that should do the job.	Guest User 1/12/2008	Share Or copy this URL: https://www.metalroofing.com/spirit/comment/10765/find/
Okay.	Todd Miller Isaiah Industries, Inc. 1/13/2008	Share Or copy this URL: https://www.metalroofing.com/spirit/comment/10766/find/
I have a metal roof that I am trying to install a 6 inch wood stove chimney through the pitch is 8/12. I have the flashing for it but, I am not sure how I should do it. Should it be put underneath the roof at the top and then screwed down with a silicone sealer? Or can I just set on top of the roof with sealer and screws? The picture you are showing goes under right? Thanks in advance Dave	Guest User 1/28/2008	Share Or copy this URL: https://www.metalroofing.com/spirit/comment/10767/find/
Yes, his picture does show it going under the roof on the uphill side. That is generally the best way to do things.	Todd Miller Isaiah Industries, Inc. 2/2/2008	Share Or copy this URL: https://www.metalroofing.com/spirit/comment/10768/find/
Nice picture, better than 1000 words for sure :) Are those rivets or metal screws ? What kind of fastener should be used in this case ?	Guest User 7/27/2010	Share Or copy this URL: https://www.metalroofing.com/spirit/comment/10769/find/
Those are screws. A gasketed screw would be best.	Todd Miller Isaiah Industries, Inc. 8/1/2010	Share Or copy this URL: https://www.metalroofing.com/spirit/comment/10770/find/
As far as chimneys (type A) and gas flues (type B) go - MasterFlash flashings are rated for type B, but is it ok to use them with wood stove chimneys which are class A ?	Guest User 8/14/2010	Share Or copy this URL: https://www.metalroofing.com/spirit/comment/10771/find/