If you would like to reply to this thread, please log in. If you do not have an Ask the Experts forum user account, create one here.
If you would like to reply to this thread, please log in. If you do not have an Ask the Experts forum user account, create one here.
We are building a new residence with about 2500 square feet of hip roof. The pitch is 4/12. It is located in Ontario, Canada about 200 km north of Toronto.
We want to have a standing seam roof in black with no striations or ribs.
According to the manufacturer of the product (a Canadian member of the MRA), pricing is very similar between their 26 gauge snap-lock product with 16" width and their 24 gauge snap-lock product with 20" width. On balance, it would seem that the 24 gauge 20" product would be a better choice.
Two questions:
1) Would one of those products have a greater chance of oil canning?
2) The builder has done a lot of 28 ga metal roofs, but has not done a standing seam. He is contemplating sub-contracting the job if he can find a good installer, but he might also do it himself. He is a perfectionist. Anything in particular that he should know re: installation difference of standing seam vs exposed fastener metal roof?
Thanks!
Ryan
5/21/2019
Kind of a toss up at that point between the slightly smaller panel at the thinner metal.
If the machine that is used to run the panels is in spec, and the roof deck is laser straight and flat, you should be in good shape.
An informed customer is the Best Customer!
5/21/2019
With an ICF foundation and engineered trusses, I would hope the roof deck is straight!
The longest roof panels will be about 19ft long. It will be Vicwest Prestige roof.
Should I expect oil canning to occur without using ribs?
Should a backer rod be installed? Is there a bulge visible from the backer rod?
Thanks!
5/22/2019
The backer rod can be run of a narrow thickness and it is non-visible in the majority of cases.
An informed customer is the Best Customer!
5/22/2019